New Graphics, bumper, and seat cover does wonders for neglected plastics.

very nice! keep it up

looks good man. that garage is empty without your other toys

Now if I could just get it orginized I would be in good shape!!!

Nice look. Are the number plates from ALBA?

Also, nice jeep, seeing the bowtie leads me to believe it has a 350, maybe bigger???

haha where do you see a bowtie? that is a warn sticker. but yeah its a super nice jeep you should see under the hood. and yes it has a chevy motor-- can you say PRO-FLO EFI? almost the same set-up that i have on my jeep

The numer plates are the one that come with the kit. I had to trim up the Alba graphics to work with my cut fenders, but I think they look pretty good on there.

The Bowtie is around the Stamped Jeep emblem on the front fender. The engine is a 67 Camaro small journal 327 with Edelbrock Fuel Injection. Not too many Jeeps out there can say that they have seen the century plus 20 mark and with 35's to boot. I did it once just to say it would and I can assure you that it won't see that speed again as long as I own it. Very scary ride!!!

i told you it was nice. oh and i see the bowtie now... i did not notice that before... i am almost done with mine. all i got left is to 4-link the rear end and i will be ready... i need to brink it up and go trail riding one day..

Nice, was that a difficult swap? looks pretty packed under there.

its actually a very easy swap. i did basically the same thing in my jeep but he has a ton of oil, transmission, fuel coolers under the hood. if they make a cooler for it then this jeep has it. all you really need for the swap is some motor mounts and depending on the tranny you might need to modify or replace the bell housing.

Your rear fenders look and awful lot like mine!!! i got a little more in the rear taken off though... looks good!!!

I started it on a Friday after work and basically worked straight through the weekend and drove it home @ 10:00 Sunday night . No exhaust, It had a carb then, and the coolers were added about 6 months later. Advanced adapters offers a kit that basically has everything you need to get the engine mounted in the right place. Then you need to do all the odds and ends to get everything hooked up.

check out novakconversions.com just like advanced just my preference