I have an 07 LTZ400 and i need advice/pictures on how to install the unit.. its a pro design dead man kill switch.. i been looking at old postings on how to install it and to be honest i cant figure it out.. so pictures would be a huge help.. thanks!

if you dont have the black blob then its easy. look for a topic by spize909 and you will see where normalz posted a diagram.

wire your tether into the orange and orange/white wire
bottom of the page

http://suzuki.theatvchannel.com/invision/i...mp;#entry738629

if you don't mind what is the black blob i bought the z400 about 2 weeks ago and i never had the plastic off it's alot different then my honda 250r

its the part that has the headlight switch and engine run switch on it. it will be on your left handle bar next to the clutch perch. the start button is on it as well

i steel have it on there

if you look inside that black blob there is i think 7 wires. you need to wire one wire of the tether to the orange wire and the 2nd wire of the orange/white wire. look at that wiring diagram and you will see what i am talking about

Read this thread - it's a step-by-step. It only works for a Normally Closed-circuit tether, so figure out what you have: Normally Closed or Normally Open. If you have a Normally Open Switch, then this won't work for you. Keep in mind, this is for the LTR-450, but the Blob wires are the same on the LTR and LTZ...

http://ltr450.theatvchannel.com/invision/i...?showtopic=1228

i have a pro design and how can you tell if it is a Normally Closed or Normally Open kill switch

it should say on the package. the normally closed switch completes the circuit with the tether installed. when it is pulled it opens the circuit killing the bike. the normally open switch has an open circuit until the cord is pulled then the circuit closes and grounds out the coil so it cant spark and kills the quad.

The pro design is a NO kill switch....

it is a dead men kill switch

the kill switch is for a battery atv or a non battery but the want you to wire it up throw stator

Sorry, that might have looked wrong. Its a Normally Open kill switch(N.O.)

sorry i have not been on a few days but will this stell work throw the black blob

no since it is normally open it will not work with the blob. you would have to wire it to the coil. I do not recommend using this type of tether. is there a possibility that you could swap the tether out?

i don't know if i can take it back with out the receipt. what kind do i need to work with the blob?

Best, smartest, safest kill tether to use would be (any brand) Normally Closed Circuit tether...

you can still get rid of the blob without having a teather..you just tie the on/off wires together

Hey here is a link I a have pro armor on mine works fine


http://www.exriders.com/vbb/showthread.php?threadid=397231